# ILLUSTRATIVE — not for manufacture Board: TRAIN-C Rev C. Package CTRL-C-02 supersedes CTRL-C-01. All identities and approvals fictional. F01: Surface finish ENIG for this exercise; authority DWG-TRAIN-C Rev C / EQ-01. No thickness or acceptance limits defined here. F02: Construction source STACK-TRAIN-C Rev C; use the released thickness entry 1.60 mm for this exercise only. Tolerance remains HOLD pending project definition. F03: Hole source HOLES-TRAIN-C Rev C; dimensions refer to finished openings, with plating stated per feature. Actual geometry/tolerances must be supplied before manufacture. F04: No material substitutions or design-intent changes without bounded written approval. Routine compensation only within the actual agreed scope. F05: Required tests/reports and applicable standards/revisions remain HOLD pending agreement. This specimen demonstrates document control, not a complete fabrication specification. CTRL-C-02 is data-consistent for the three listed issues but is NOT production-released: remaining tolerance/geometry/test requirements block release.